Minebea Intec Maxxis 5 Phase PR 5900/81, Operating Instructions Manual

Page: 39 / 94

Modbus-TCP master @admin
Communication error
ModBus-TCP module
Activate module
IP address
I/O Type
Input
SPM address %MX
Show message
Phönix 1: 16IN:16OUT active
0.0.0.0
Digital input
1
0
Default Input- Input+ Save
[IP address]
Selection: speak with the responsible system administrator
[I/O type]
Selection: Digital input, Digital output
[Input/Output]
Selection: Input+/ (higher), Input-/Output- (lower)
[SPM address %MX]
Set: Fixed SPM address, see Chapter 8 .
5.4.5 Limit values: coniguration
Each limit consists of a switch-on and a switch-of point for deinition of a hysteresis.
The 4- values for each weighing point are entered according to the same pattern. The
values may be within -0,01 x Max and 1,01 x Max for the related scale.
For the SPM addresses for the limits, see Chapter
8 .
These do not have a function for batching.
6. Check the ☑ box to activate the module.
7. Select and conirm the individual settings using the cursor.
8. Press the [Default] soft key to return to the factory settings, if required.
9. Finally, press the [Save] soft key to save the settings.
5 Getting started Phase PR 5900/81
Minebea Intec EN-37