Minebea Intec Maxxis 5 Phase PR 5900/81, Operating Instructions Manual

Page: 14 / 94

Status icons in the info line
Icon Description
Remote control via VNC (Virtual Network Compu-
ting) is active.
General warning
- The clock battery is empty.
- The standby battery is empty.
The standby battery is too hot and is not charging.
If this does not go away, the ambient temperature
must be checked, see PR 5900 installation manual
under [Technical data] - [Environmental inluences]
- [Ambient conditions] .
- An unsupported USB device is connected.
- The maximum current of i
max
= 200 mA has be-
en exceeded.
Check newly connected devices.
USB stick was recognized and is operational.
Stick is in use and may not be removed.
Conlict in the network settings of the IP address.
Interface (CX1) was detected. However, there is no
connection to the operator terminal.
3.1.3 LEDs
Operating status Color LED status Description
Normal operation Of
System ready (standby) Red Continuous illu-
mination
The display is switched of.
Power interruption
<5 seconds
Red Slow lashing After 5 seconds, the device re-
turns to normal operation.
Power interruption
>5 seconds
Red Fast lashing The device is running a data ba-
ckup. Once power is restored, the
device returns to normal operati-
on (LED of).
After the data backup,
there is still a power in-
terruption.
Of The device switches of.
Of The device initiates a warm start,
see PR 5900 operating instruc-
tions.
Phase PR 5900/81 3 Operating
EN-12 Minebea Intec