MIMAKI Tx300P-1800B, Operation Manual, Page: 93 / 144

4-5
1
2
2
4
5
6
Chapter 4 Maintenance
MAINTENANCE MENUs at-a-glance
Item Set value Meaning
STATION
MAINTENANCE
For carrying out maintenance on the carriage and station periphery.
CARRIAGE OUT
(
P.4-6)
Moves the carriage out, for carrying out cleaning of the cap
periphery, head, wipers, etc.
NOZZLE WASH
(
P.4-7)
1 to 99min
Soaks the nozzle surfaces in maintenance cleaning fluid, for carrying
out recovery from nozzle clogging or bent.
DISWAY WASH
(
P.4-9)
Executes washing of the suction pump tubes.
CUSTODY WASH
(
P.4-10)
1 to 99min
Carried out when the machine is going to be out of use for an
extended period. Washes the nozzles and tubes beforehand, to keep
the machine in fine condition.
WIPER EXCHANGE
(
P.4-18)
Used when replacing the wiper. If the wiper is replaced, the number
of times the wiper was used that is managed in this device is reset.
NOZZLE
RECOVERY
(
P.4-14)
For printing using another nozzle, if nozzle wash and so forth fail to effect recovery from nozzle missing, etc.
PRINT Used to print a pattern and to check and/or register clogged nozzles.
ENTRY Registers the faulty nozzle identified by “PRINT”.
RESET Resets a registered faulty nozzle.
CHECK Checks recoverable printable conditions.
TEST PRINT ON/OFF
Enables or disables the configuration of the nozzle recovery function
during a test print.
AUTO MAINT.
(
P.4-16)
For having the various maintenance functions executed automatically. Set the execution interval for each
maintenance function.
REFRESH
The setting is
different
depending on your
ink type.
For setting the activation interval for refresh.
PUMP TUBE
CLEANING For setting the activation interval for the ink discharge passage
cleaning.
CLEANING
INTERVAL For setting the activation interval for the head cleaning.
TYPE NORMAL/ HARD
*1
*1. "Soft" can also be set when reactive dye ink Rc 400 or Rc 500 is used.
Select the cleaning type for head cleaning.
FILL UP INK
(
P.4-18)
Supplies ink to correct nozzle clogging.
REPLACE
WasteInkTank
(
P.4-19)
Resets or corrects the used count for the waste ink tank.
BELT WASH
UNIT
(
P.4-21)
Move the belt wash unit to the maintenance position and clean the washing belt and the inside of tray.
BELT ADHESIVE
(
P.4-24)
Peel off adhesive Peel off the adhesive.
Applying Adhesive Apply the adhesive.
BELT CLEANING
(
P.4-30)
Used to clean feeding belt.
REPLACE WATER
(
P.4-20)
DRAIN Drains water from the wash unit.
SUPPLY Supplies water to the wash unit.
CLEANING WASH
TRAY
Clean the washing tray and the washing brush.
COUNTER RESET
(
P.4-31)
Adhesive
Initializes the counter settings.
Absorb Roller