MIMAKI Tx300P-1800B, Operation Manual, Page: 129 / 144

5-9
1
2
2
2
5
6
Chapter5 Troubleshooting
An error was detected in the waveform
being printed.
• Turn off the power to the machine and turn it
on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error occurred in the power supply of
the slider PCB.
An error occurred in the main PCB.
An error occurred in the power supply of
the first Station IV PCB.
An error occurred in the power supply of
the second Station IV PCB.
An error occurred in the power supply of
the third Station IV PCB.
An error occurred in the power supply of
the slider PCB.
The memory size is insufficient.
Message Cause Solution
ERROR 18e
FLS NOT COMP
ERROR 18f
OFFSET START
ERROR 18f
OFFSET END
ERROR 1ce
SLIDER PCB V24
ERROR 1cf
SLIDER PCB V1R8
ERROR 1d9
Main PCB V48-1
ERROR 1db
Station4 PCB V48
ERROR 1dc
Station4 PCB V24
ERROR 1dd
Station4 PCB V24-A
ERROR 1db
Station4-2 PCB V48
ERROR 1dc
Station4-2 PCB V24
ERROR 1dd
Station4-2 PCB V24-A
ERROR 1db
Station4-3 PCB V48
ERROR 1dc
Station4-3 PCB V24
ERROR 1dd
Station4-3 PCB V24-A
ERROR 1de
SLIDER PCB V1R2
ERROR 1df
SLIDER PCB V2R5
ERROR 1e0
SLIDER PCB V3R3
ERROR 1e1
SLIDER PCB V5
ERROR 1e2
SLIDER PCB V48
ERROR 1e6
PRAM SIZE SHORTAGE