MIMAKI Tx300P-1800B, Operation Manual, Page: 65 / 144

3-5
1
2
3
4
5
6
Chapter 3 Setup

Reflect The Content Set In [Temporary] To
Setup 1 To 4
1
Press
(MENU)
in LOCAL.
2
Press to select “Temporary”,
and press the key.
• SETUP MENU will be displayed.
3
Press to select and set each item
in the setup menu list.
• Please see the reference page in the setup menu
list for detailed configuration procedure.
4
Display the last page of Temporary and
select “SAVE SETTING”, and press the
key.
• Selection screen of the save location will be
displayed.
5
Press to select the location
selected (SETUP 1 to 4), and press the
key.
• Save confirmation screen will be displayed.
6
Press the key.
• Settings of Temporary will be saved to the location
selected in step 5.
7
Press the key several times to
end the setting.
Reset the registered contents
Reset the contents registered to SETUP 1 to 4.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4 to
be reset and press the key.
• SETUP MENU will be displayed.
3
Press
(
<<).
4
Press to select “RESET
SETTING”, and press the key.
• Confirmation screen of reset settings will be
displayed.
5
Press the key several times to
end the setting.
Setting of Media Correction
Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
A pattern for media correction is printed and a media-
feeding rate is corrected.
1
Set a media. ( P.2-4)
2
Press
(MENU)
in LOCAL.
3
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
4
Press to select “FEED COMP”,
and press the key.
5
Press the key twice to print a
correction pattern.
6
Check the correction pattern and enter a
correction value.
• A screen for entering the correction value will be
displayed.
•
Enter a correction value in “+”
:
The boundary between the two bands is widened.
• Enter a correction value in “-” :
The boundary between the two bands is
narrowed.
• When you change the correction value by “30”, the
width of the boundary changes by about 0.1 mm.
• On completion of [MEDIA COMP.] during use of a roll
media, the media returns to the printing origin. Then the
roll media in the rear of this machine will slacken.
Before printing, take up the slack in the roll media by
hand; a loose roll media can result in an inferior image
quality.
• When printing with a take-up device, set the media first
and then perform media correction.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
Media
advance
direction