MIMAKI Tx300P-1800B, Operation Manual, Page: 111 / 144

4-23
1
2
2
4
5
6
Chapter 4 Maintenance
6
Press the key.
• The wash unit will move towards the back of the
machine.
7
Remove the hand screw and rotate the
right and left absorb roller fix BKT.
• The absorb roller is located inside the machine
towards the back.
8
Remove the absorb roller from the
machine.
9
Remove any water from the absorb roller.
(1) Remove the screws from both ends with a
screw driver and perform cleaning with
removing frames one by one.
(2) Use tap water, etc. to wash away any
impurities from the roller.
(3) Once impurities have been washed away,
use a waste cloth (Bemcot, etc.) or similar
cleaning aid to wrap around the sponge
section and remove any water.
(4) Once it has been dried well enough, reinstall
section.
10
Reinstall the absorb roller
• Reset the counter is a warning message is
displayed.
“Resetting the Counter”(
P.4-31)
11
Once cleaning has been completed, press
the END key.
• The cleaning completed confirmation screen will
be displayed.
12
Press the key.
• The wash unit movement confirmation screen will
be displayed.
13
Press the key.
• The wash unit will move back to its original
position.
14
Install the feeding unit.
• Reinstall the feeding unit which was removed.
15
Press the key.
• The maintenance completed screen will be
displayed.
16
Press the key.
• At least two people should be involved in removing
the absorb roller.
• Do not twist the sponge.
Absorb roller fix BKT
Hand screw
Absorb roller
• Do not twist the sponge.
• Move the absorb roller to the center to
avoid a gap and then fix.
• Please be sure to install the feeding unit
when this screen is displayed.
Remove the feeding unit
from the machine
[ENT]
BELT WASH UNIT