MIMAKI Tx300P-1800B, Operation Manual, Page: 31 / 144

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow ....................................................... 2-2
Turning the Power ON/OFF .......................... 2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media ............................................. 2-4
Setting Feeding and Take-up unit ............... 2-4
Adjusting the Head Height .......................... 2-5
Printing Width .............................................. 2-6
Mounting the fabric roller ............................. 2-6
Using the tension bar to set the roll media .. 2-7
Setting roll media without using
tension bar ................................................ 2-12
Using the peeling to set the media ............ 2-14
Setting media without using peeling .......... 2-14
Feeding/ Take-up device ........................... 2-17
Changing the printing origin ...................... 2-20
Pressure roller weight adjustment ............. 2-20
Peeling sensor positioning adjustment ...... 2-21
Eradicating Media Sagging with the
Curved Bar ................................................ 2-22
Removing the smoother roller and
replacing frames ........................................ 2-23
Test Printing ................................................2-24
Test Printing ............................................... 2-24
Set the media feeding .................................2-26
Flow of media feeding correction ............... 2-26
Head Cleaning ............................................2-27
About head cleaning .................................. 2-27
Perform head cleaning depending on
the test printing result ................................ 2-27
Setting of Media Correction .........................2-27
Setting of Media Correction ....................... 2-27
If the Positions of Dots Shift... .....................2-28
Printing Data ...............................................2-28
Starting a Printing Operation ..................... 2-28
Stopping a Printing Operation .................... 2-29
Deleting Received Data (Data Clear) ........ 2-29
Behavior after printing has been
completed .................................................. 2-29
To reduce waste of media ......................... 2-29
Chapter 2
Basic Operations