Drawing data
2-24
Cutting a media
For a roll media, two ways are available to cut the media after printing is completed, as follows.
Auto cut
A media is automatically cut after printing is completed.
1
Cut the media automatically after print-
ing is completed.
Manual cut
Cut the media at an optional position by using the keys on the operation panel.
1
Press the
keys
in the local mode.
• It enters the printing origin setting mode.
• Feed the media to the position to cut by pressing the
key.
2
Press the
key.
3
Press the
key.
• This machine cuts the media.
• It returns to the local mode after cutting is
completed.
• Pay attention so that printed surface does not touch to a floor or other printed surfaces when
the media is cut.
• When the take-up device is used, roll up the cut media by operating a switch of the take-up
device.
• For the Auto cut function, it is required to set. (The Auto cut function is set to “OFF" when pur-
chased.)
• When the Auto cut function is set to "OFF", cut a media according to the operations of "Manual
cut".
OR I G I N SE TUP
0 . 0
- - - -
MED I A CUT
< ENT >
MED I A CUT T I NG
P L EASE WA I T
Summary of Contents for JV33-130BS
