MIMAKI JV33-130BS, Operation Manual, Page: 104 / 206

3-48
Inputting weight of the cartridge after initial ink filling
When the initial ink charging ( P.4-24) was finished after [DISCHARGE & WASH], the screen to input the
weight of the 600cc cartridge is displayed.
1
When ink filling is completed, the fol-
lowing screen is displayed.
2
Remove the 600cc cartridge and measure the weight.
• Be sure to measure the weight of the eco case including the 600 cc ink pack.
3
Reset the 600 cc cartridge.
4
Pressing the keys
input the weight of the 600cc cartridge.
• Press the keys to move to another digit.
• Press the keys to input the weight.
5
Press the key.
6
Press the key.
• If there is a 600 cc cartridge, which the quantity of remaining ink is not set, the screen will
return to the Step 1.
Repeat the procedures from the Step 1 to 6 for all the 600cc cartridges set in this machine.
• When the setting for the quantity of the remaining ink of all the 600cc cartridges is com-
pleted, return to the local mode.

When an error occur in the Step 6
This function stores the calculated quantity of remaining ink in the ink chip of the 600cc cartridge.
If the 600cc cartridge is removed or there is a problem on the contact of this
device and the ink chip, the data storage in the ink chip cannot be performed.
In this case, the message on the right will be displayed.
If the message is displayed, reinsert the 600cc cartridge and follow the proce-
dures from the Step 3 again.
• This machine recalculates usable amount of remaining ink by entering the weight of the 600
cc cartridge.
• Weigh the cartridge exactly down to the gram. Entering a larger weight than the actual one
may cause dot missing.
I n k L e v e l S e t . . C . . . . .
0 4 0 0 g
I n k L e v e l S e t . . C . . . . .
0 5 5 5 g
I n k L e v e l S e t . . C . . . . .
0 5 5 5 g OK ? : e n t
* * * 6 0 0 c c E r r o r * * *
P r e s e r v a t i o n f a i l u r e