MIMAKI JV33-130BS, Operation Manual

Page: 38 / 206

2-6
Setting medias
Useable medias
This machine can be used with roll media and leaf sheet media.
For useable medias, refer to P.1-14 "Usable sizes of media".
Adjusting the head height
Adjust the head height according to the thickness of the media used.
Adjusting the head height
1
Move the carriage to the platen.
• When the device is turned on :
Execute [ST.MAINTENANCE] - [CARRIAGE OUT]
(
P.4-5 Step 1,2 )
• When the device is turned off :
Open the front cover, then move the carriagewith
hand.
2
Loosen two screws located at the front.
• Loosen the screws, rotating by one turn with a
screwdriver.
• When you use a media of 1mm thickness or less with BS ink, be sure to set the head height to
Thin. If you set the head height to Thick and use, the head gap (the height of the head nozzle
face from the media) widens too much and ink spatters. In this case, we cannot guarantee the
image quality.
• Adjust the head height prior to setting of the media. If the head height is adjusted after the
media is set, this may cause media jamming, deterioration of the drawing quality or head dam-
age.
• The range of the initial head height is adjustable by 2 levels according to the purpose of use.
• The range of the printing height of this machine is from the general printing ( 2 mm/3 mm) (Set
to 2 mm at shipping)
• If the drawing quality is set to "Bi-D" ( P.3-14) , perform "DROP POSITION" of the mainte-
nance function after the head height is adjusted. ( P.4-26)
Carriage
Screws