MIMAKI JF-1610, Operation Manual

Page: 42 / 142

2-10
Execution of head cleaning
When a correct pattern is not obtained in the test drawing, perform the head-cleaning. As for the head
cleaning, the following 3 types are available.
When cleaning with “Normal” or “Hard”
1
Press the key in the local
mode.
2
Select the cleaning type with or
keys, press the key.
3
Select the head and set execution/non-
execution of cleaning.
(1) Select the head with or keys.
(2) Select execution/non-execution of the head
cleaning
with or keys.
• Select execution of cleaning for every head.
Execute Cleaning ： A color of an ink cartridge being set is displayed.
Not Execute Cleaning
： “
_
”
is displayed
4
Press the key.
• Cleaning is started.
• When the cleaning is completed, a mode is returned to the local mode.
5
Execute test drawing and check the result of the test drawing.
• Repeat cleaning and test drawing until normal result is obtained.
normal
To be used if ten odd numbers of the lines are missing when the test pattern is
made. Suction and wiping with the cap will be performed.
P.2-10
wiping
To be used if several numbers of the lines are missing when the test pattern is
made. Only the wiping with the wiper will be performed.
P.2-11
hard
To be used when the missing of the lines is not improved with the “ Normal ”
cleaning. To be absorbed strongly with the cap.
P.2-10
• When the head cleaning is performed, the UV lamp will automatically be put off. (Around 5
minutes will be required for putting on the light again.)
• When making the test drawing, if the setting is made so that the UV lamp is not put on
( P.3-12), the cleaning will be performed quickly. (However, in the case when the media
liable to reject the ink is used, the ink will flow out and checking of the test drawing will
become difficult.)
C L E A N I NG
T Y P E : n o r m a l
CLEANING
C L E A N I NG
T Y P E : h a r d
ENTER
C L E A N I NG
H E A D [ MC
Y K K Y CM ]
C L E A N I NG
H E A D [ MC K K Y CM ]
ENTER