MIMAKI JF-1610, Operation Manual

Page: 27 / 142

1-9
1
Before Use
UV irradiation device and Indicator
UV irradiation device
The UV lamp is set to OFF automatically, if no drawing is conducted
for 30 minutes. Set the UV lamp to OFF if drawing is not conducted for
a long time (more than 30 minutes).
（
P.3-8 "Turing the UV lamp
off" ）
Function of indicator
Functions of the Indicator on the top left of this unit are described here.
The indicator represents 3 modes. A state of each mode is indicated by the indicator of this unit.
• Do not expose your naked eyes directly to the light
irradiated from the UV lamp when it lights.
• Do not touch the lamp when it is being lit or just after it is
set OFF. It may cause a burn injury, as it is very hot.
Mode State of machine Outline
Ready mode
ON (green) REMOTE MODE
Blinking
(green)
REMOTE MODE (at drawing)
OFF LOCAL MODE
After cooling mode
ON
(orange)
[Drawing disabled]
UV lamp being cooled
(5 minutes) The UV lamp goes OFF in the following cases:
• When operation for setting the UV lamp OFF is
executed.
• When 30 minutes or more have elapsed after drawing.
• When an error has occurred in this unit.
After the UV lamp has been set OFF, it is cooled.
The UV lamp cannot be set ON again and this unit
cannot start drawing. Wait for going the light OFF
for a while.
Blinking
(orange)
[Drawing disabled]
At preparation for lighting the UV
lamp
OFF
UV lamp has been lit or has been
turned OFF
Error mode
ON
(red)
[Drawing disabled]
An error occurred
(The UV lamp goes OFF.) (1) Error in UV power unit
(2) UV lamp overheated
The UV lamp goes OFF. Drawing operation of this
unit stops.
(3) When the UV irradiation unit does not function
normally.
(4) Occurrence of an error on the unit.
OFF Normal
UV irradiation
device
Red
Orange
Green