Page
8
of
33
Tools
Phillips-Head Screwdriver
Needle Nose Pliers
2.5mm Hex Key
8mm Socket or Wrench
10mm Socket or Wrench
Locate your Z screw seat plate and UHMW screw seat. Place the UHMW
screw seat on top of the screw seat plate. Make sure the pocket of the
UHMW screw seat is facing up as shown.
Secure the UHMW screw seat to the screw seat plate using (2) M5x16
machine screws and (2) M5 nylock nuts. Do not over tighten or you may
deform the UHMW screw seat.
The front of the X plate is the face with the
recessed pockets. The top of the X plate is
the section with the “U” cutout, as shown
above. Place the screw seat plate on the X
plate near the bottom center set of holes.
Make sure the UHMW screw seat is
pointing towards the top of the X plate.
Place a M4 split lock washer on (2) M4x12
machine screw and insert the screws
through the back of the X plate to secure the screw seat plate to the X plate.
