Page
20
of
33
Preload the set screws in the inside corner joiners. (2) set screws for each
corner joiner. Side the corner joiners, (2) on each side - (4) in total, in the
1456 extrusion oriented where they terminate against the end of the 1465
extrusion. Repeat this process with the 1235 extrusion.
Slide the 1465 extrusion into the front set, middle set, and rear set of legs. Sit them on the gussets. Slide the
1235 extrusion on the left and right, between the front and middle legs, and
the rear and middle legs. You may have to adjust the middle legs to allow
the 1235 extrusion to fit. Place (2) drop-in t nuts in each 1465 and 1235
extrusion to correspond with each gusset. Push the drop-in t nuts to align
with the gusset holes and secure with M5x8 button caps. Tighten all
gussets and inside corner joiner while checking square. Tighten the lower
gussets and inside corner joiners for the middle legs.
Locate the foot plate. Attach the foot plate
using (2) 5/16x3/4 button cap screws for
each leg. Locate the leveling feet. Screw
one into the center of each foot plate.
Get some help and flip the frame onto the leveling feet. Please do not attempt to do this without assistance
from others.
