Page
31
of
33
The Y homing wire will
not
run through the Y drag chain.
Check the placement of your drag chain mounts on the right 2650 frame extrusion. The drag chain that is in
front of the Y midspan support should be 16” from the Y end plate at the front of
the machine. The drag chain
behind the Y mid span support should be 1” from the Y midspan and 1” from the rear Y end Plate respectively.
The drag chain mount on the underside of the right Mega V Y extrusion should be 24” from the front Y end
plate.
The Y homing wire will be zip tied to the underside of the Y drag chain
mounts attached to the 2650 frame. Attached the homing wires to the Y
homing switch and secure the wire to the drag chain mounts. (the angle of
the switch pictured right is to aid in connecting the wires to the switch and
not how the switch should be positioned).
Curl The drag chain towards the front of the machine. Connect the end of
the drag chain to the slot in the front most drag chain mount using a M4x12
machine screw and a M4 nylock nut.
Move the gantry all the way forward. Zip tie the drag chain to the slot on the second drag chain mount
attached to the 2650 frame extrusion before the chain curls up.
