Page
13
of
33
Get one section of long gear rack. Place M5x20 Button cap screw through
the holes (12) of the gear rack keeping the screws uniform. Spin a large t
nut a few turns on each screw. Leave the t nuts loose. Repeat process for
the remaining long gear rack and the short gear rack.
Slide the t nuts into the top of the Mega V extrusion with the gear rack
teeth pointing out from the extrusion, away from the v groove. Leave the
rack loose. The (2) 2650 Mega V extrusions will get the long rack. The 1465
Mega V Extrusion w/logo will get the short rack.
Designate one 2650 Mega V Extrusion as the right extrusion. Lay the
extrusion on it’s side with the rack teeth facing up.
Locate a drag chain
mount. Place (3) drop-in t nuts in the groove on the opposite side of the
extrusion from the gear rack, near the left end of the extrusion. Put M5
split lock washers on (3) M5x12 button cap screws. Position the drag chain
mount with the slot facing to the left and attach the mount to the extrusion
using the M5x12 Button caps with lock washers and the drop in t nuts.
Locate the
1465 Mega V Extrusion with the logo. Lay the extrusion on it’s
side with the logo down and the rack teeth pointing up. Locate (2) drag
chain mounts. Place (6) drop-in t nuts in the groove on the opposite side of
the extrusion from the gear rack, near the right end of the extrusion. Put
M5 split lock washers on (6) M5x12 button cap screws. Position the drag
chain mounts with the slot facing to the right and attach the mounts to the
extrusion using the M5x12 Button caps with lock washers and the drop in t
nuts.
