Miller Robotic Interface II, Owner'S Manual

Page: 44 / 78

OM-172 324 Page 38
10-8. Selecting Purge Time
1 Purge Display
The purge time can be varied be-
tween 0.0 (zero) and 25.0 seconds.
1
Increase
M i g T y p e
I n d u c t .
>P u r g e
Vo l t a g e
T i m e
0 . 0
T i m e
2 5 . 0
Press
Mode Select
Access
Setup
Display
Use Purge only when a weld
program is not running.
Figure 10-8. Purge Display
10-9. Selecting Voltage Sensing Method
1 Voltage Feedback Display
When using the 17 Pin setting, arc
voltage feedback is through the
welding power source and the feed-
back signal is sent through the
17-pin cord to the feeder.
If the 17 Pin setting is used, it is rec-
ommended that the voltage sens-
ing terminals on the welding power
source be used to monitor arc volt-
age at the workpiece.
When using the V. Sense setting,
arc voltage feedback is through the
voltage sense leads connected to
the feeder. Use this setting when
there is more than 50 ft (15 m) of
weld cable used.
I n d u c t .
P u r g e
>V o l t a g e
A r c S t a r t
Co n t r o l
Fe e d b a c k
>1 7
P i n
1
Co n t r o l
Fe e d b a c k
>V .
S e n s e
Increase
Press
Mode Select
Access
Setup
Display
Figure 10-9. Voltage Feedback Display