Miller Robotic Interface II, Owner'S Manual

Page: 31 / 78

OM-172 324 Page 25
1 Start Parameters Display
Parameter ranges are as follows:
Seconds, 0-2.5 Sec. If value set is
zero (0), there is no Run-In
sequence.
Volts, 10.0-38.0 Volts
Wire Feed Speed, 50-780 inches
per minute, IPM
Go on to Figure 8-5.
1
Set Desired Voltage
Increase/
Set Desired
Increase/
Decrease
Set Desired Time
Increase/
Decrease
>S t a r t
0 . 2 S e c
2 4 . 0 V o l t
9 0 I P M
S t a r t
0 . 5 S e c
>1 8 . 0 V o l t
9 0 I P M
S t a r t
0 . 5 S e c
1 8 . 0 V o l t
>2 0 0 I P M
S t a r t
>0 . 5 S e c
2 4 . 0 V o l t
9 0 I P M
Decrease
Parameter
Select
Wire Feed Speed
Parameter
Select
Parameter
Select
Parameter
Select
>S t a r t
0 . 5 S e c
1 8 . 0 V o l t
2 0 0
I P M
Increase
Proceed to next figure.
Figure 8-4. Setting Start Sequence Display
1 Weld Parameters Display
Parameter ranges are as follows:
Volts, 10.0-38.0 Volts
Wire Feed Speed, 50-780 Inches
Per Minute, IPM
Go to Figure 8-6.
Parameter
Select
W e l d
2 0 . 0 V o l t
>2 0 0 I P M
Set Desired Wire Feed Speed
Increase/
Decrease
>We l d
2 0 . 0 V o l t s
4 2 0
I P M
Proceed to next figure.
Increase
1
W e l d
>1 8 . 0 V o l t
2 0 0 I P M
Increase/
Decrease
Set Desired Voltage
Parameter
Select
Figure 8-5. Setting Weld Sequence Display