Miller Robotic Interface II, Owner'S Manual

Page: 20 / 78

OM-172 324 Page 14
1 Mode Select Button
When unit is turned On, Process is
the default mode, at other times,
use mode select button to select
Sequence.
2 Parameter Select Button
Use parameter select button to se-
lect parameters.
3 Preflow Parameters Display
Preflow can be adjusted from 0-9.9
seconds. If value set is zero (0),
there is no Preflow sequence.
Go to Figure 6-3.
3
Set Desired Time
Increase/
Decrease Proceed to next figure.
>P r e f l o w
0 . 0 S e c
P r e f l o w
>0 . 0 S e c
>P r e f l o w
1 . 2 S e c
Increase
Parameter
Select
Parameter
Select
Parameter
Select
2
P r o c e s s
C a r d
>S e q u e n c e
>P r e f l o w
0 . 0 S e c
Mode Select
1
Figure 6-2. Setting Preflow Sequence Display
1 Weld Parameters Display
Parameter ranges are as follows:
Trim (Arc Length), 0-99
Wire Feed Speed, 50-780 Inches
Per Minute, IPM
Go to Figure 6-4.
Parameter
Select
W e l d
6 0 T r i m
>2 0 0 I P M
Set Desired Weld Sequence
Increase/
Decrease
W e l d
6 0 T r i m
3 0 0 I P M
Proceed to next figure.
Increase
1
W e l d
>5 0 T r i m
2 0 0 I P M
Increase/
Decrease
Set Desired Weld
Parameter
Select
Sequence Trim
Wire Feed Speed
Figure 6-3. Setting Weld Sequence Display