Miller Robotic Interface II, Owner'S Manual

Page: 32 / 78

OM-172 324 Page 26
1 Crater Parameters Display
Parameter ranges are as follows:
Seconds, 0-2.50 Sec. If value set is
zero (0), there is no Crater
sequence.
Volts, 10.0-38.0 Volts.
Wire Feed Speed, 50 to 780 inches
per minute, IPM.
Go to Figure 8-7.
Parameter
Select
>C r a t e r
0 . 0 2 S e c
2 4 . 0 V o l t
9 0
I P M
C r a t e r
0 . 1 2 S e c
>1 8 . 0 V o l t
9 0 I P M
Set Desired
Increase/
Decrease
Parameter
Select
Set Desired
Increase/
Decrease
C r a t e r
0 . 1 2 S e c
1 8 . 0 V o l t
>2 0 0 I P M
Set Desired Time
Increase/
Decrease
C r a t e r
>0 . 1 2 S e c
2 4 . 0 V o l t
9 0
I P M
Parameter
Select
Proceed to next figure.
Increase
>C r a t e r
0 . 1 2 S e c
1 8 . 0 V o l t
2 0 0
I P M
Wire Feed Speed
Voltage
Parameter
Select
1
Figure 8-6. Setting Crater Sequence Display
1 Burnback Parameters Display
Parameter ranges are as follows:
Volts, 10.0-38.0 Volts
Seconds, 0-0.25 seconds. If value
set is zero (0), there is no Burnback
sequence.
Go to Figure 8-8.
1
Parameter
Select
>B u r n b a c k
0 . 0 0 S e c
1 8 . 0 V o l t
B u r n b a c k
0 . 1 2 S e c
>1 6 . 0 V o l t
Set Desired
Increase/
Decrease
Set Desired Time
Increase/
B u r n b a c k
>0 . 1 2 S e c
1 8 . 0 V o l t
Burnback Volts
Proceed to next figure.
Increase
>B u r n b a c k
0 . 1 2 S e c
1 6 . 0 V o l t
Parameter
Select
Parameter
Select
Decrease
Figure 8-7. Setting Burnback Sequence Display