Miller Robotic Interface II, Owner'S Manual

Page: 43 / 78

OM-172 324 Page 37
10-6. Selecting Voltage Correction
1 Mig Type Display
With DVC Voltage Correction On,
the unit uses closed-loop feedback
from the 17-pin cord or voltage
sensing leads to maintain set volt-
age parameters.
With DVC Voltage Correction Off,
feedback from the arc is not used
for closed-loop feedback to main-
tain voltage parameters. Feedback
from the arc is still used for other
functions.
Be sure voltage sensing leads are
connected or voltage feedback is
available through the 17-pin recep-
tacle via the welding power source.
1
Increase
Vo l t a g e
Co r r e c t i o n
>D V C
O n
S e c u r i t y
A c c e s s
>M i g T y p e
I n d u c t .
Vo l t a g e
Co r r e c t i o n
>D V C
O f f
Press
Mode Select
Access
Setup
Display
Figure 10-6. Mig Type Display
10-7. Selecting Inductance
1 Inductance Display
The inductance level can be varied
between 0 (zero) and 99.
1
Increase
Ac c e s s
M i g T y p e
> I n d u c t .
P u r g e
Le v e l
3 0
Le v e l
9 9
Press
Mode Select
Access
Setup
Display
Figure 10-7. Inductance Display