Milestone MacroPATH Basic QX Series, Operator'S Manual

Page: 42 / 128

MacroPATH and MacroPATH Basic QX Series MM161-001
– Operator Manual
42
3.4.8.2 Optical Zoom Settings
This screen shows the zoom levels for Standard or Extended setting.
To set Standard or Extended Zoom refer to chapter 3.6.5.
The figure below shows the default settings.
If there is the Table top camera holder (CODE 370455) with MACROSTAND WA cutting board (REF
370285) we recommend using the default settings with standard zoom as in the figure above.
With Table top camera holder (CODE 370455) with MACROSTAND XL cutting board (REF 370606) we
recommend using the values shown in the table below with standard zoom:
It is nevertheless possible to change the single zoom steps manually by clicking on the individual boxes and
entering the required value.
It is only possible to enter whole numbers.