Settings
100
Water plus
You can select which function is
incorporated into the
Water +
Extra.
Options
–
Extra water
(factory setting)
The water level is increased in the
wash and rinse stages of the
programme.
–
Extra rinse
An additional rinse cycle is carried
out.
–
Extra water + rinse
The water level is increased in the
wash and rinse stages and an
additional rinse cycle is carried out.
Maximum rinse level
Important for allergy sufferers as an
excellent rinsing result is achieved.
The water level in the rinse cycles can
be permanently set to the highest value.
The water consumption will be
increased.
The maximum rinse level is deactivated
as standard.
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down. Hot suds can damage
plastic drainage pipes.
Suds cooling takes place when the
Cottons
programme with a temperature
of 70°C or higher is selected.
Suds cooling must be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a laundry tub or trough.
– where the drainage pipes are rated
less than 70°C.
Suds cooling is deactivated as
standard.
Low water pressure
If the water pressure is below 100 kPa
(1 bar), the programme will be
cancelled and the fault message
Water
intake. See
will appear.
If the on-site water pressure cannot be
increased, activating this function will
prevent the programme from being
cancelled.
Low water pressure is deactivated as
standard.
