Problem solving guide
70
Fault messages at the end of a programme
Problem
Possible cause and remedy
Check detergent
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10% increments.
Use less detergent next time and follow the
manufacturer's instructions on dosage given on
the packaging.
Hygiene info: Run a
programme at min.
75°C or "Clean
machine'"
programme
When washing, a wash programme using a
temperature above 60°C has not been run for a long
time.
Turn the programme selector to
Further
programmes
/
.
Touch the
sensors until
Maintenance
appears
in the display.
Touch the
OK
sensor.
The following appears in the display:
Clean machine
Touch the
OK
sensor.
Run the
Clean machine
programme using the Miele
IntenseClean machine cleaner or a universal
powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
Check hot water
intake
The water inlet for hot water is blocked or turned off.
The programme was carried out using cold water.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the
OK
sensor.
