Miele G 8066, Operating Instructions Manual

Page: 35 / 64

2. Setting the DOS 2 rinsing
agent dosage concentration
level and venting the
dispensing system
(Programming level 3)
2.1 Selecting the rinsing agent
dispensing method
You must first call up
Programming
level 3 as follows:
^
Switch off the machine with the
Z
button.
^
Press and hold A and
6
at the
same time and, whilst doing so,
switch the machine on with the On
button
Y
.
The current programme status P... will
show in the display.
The
p
indicator light will come on.
^
Press the y button three times. 3
will appear in the display
(Programming level 3).
Then alter the rinsing agent dispensing
method as follows:
^
Press the z button once.
3.01 will appear in the display.
^
Press the A button once. Either 0 or
1 will appear in the display.
0 = Built-in pump, external container
(G 8066 and G 8066 WES)
1 = Built-in pump and built-in container
(G 8066 DOS and G 8066 WES DOS)
^
Press the A button repeatedly until
the option you want appears.
Proceed to step 2.4 if you do not want
to make any other changes to settings
in this programming level.
2.2 Setting the rinsing agent dosage
concentration level
Set the concentration level
according to the manufacturer's
recommendations.
Example: If the manufacturer
recommends a concentration level of
0.03 %, a value of 030 should be set.
^
Call up Programming level 3
(see
2.1 ).
Then, or if you were already in
Programming level 3, set the dosage
concentration as follows:
^
Press the z button repeatedly until
3.02 appears in the display.
^
Press the A button.
The rinsing agent dosage
concentration level will appear,
displayed as a %:
000
-
100
= 0.0 % - 0.1 % dosage
concentration level ( 030 = 0.030 %,
the factory default setting).
^
Press A repeatedly or hold pressed
in until the required value appears in
the display.
The dosage concentration level has
now been set.
Value set:
Proceed to step 2.4 if you do not want
to make any other changes to settings
in this programming level.
Programming special functions
35