•
41
•
7. After reviewing the
fi
rst set of results, choose one of the following based on the type of testing
you are doing:
•
If you are testing jars only, test the next set of jar posts (if you have more than one set of
posts), or test the next jar in the string. Refer to
Determining a test pattern
in this chapter.
•
If you are testing jars and straps, follow the steps in
Attaching the cable to a strap
in this
chapter.
Attaching the cable to a strap
1. Remove the red clamp or probe from the red (+) terminal.
2. Attach the red clamp or probe at the end of the strap above the black (–) terminal on the next
jar. Refer to
Figure 6
.
Figure 6. Attaching the cable to a strap
3. Choose one of the following based on the number of posts the jars have:
•
If the jar has more than one set of posts, attach the black and red clamps or probes to the
next set of posts on the jar.
•
If the jar has one set of posts, test the jar connected to the jar you just tested. Follow the
steps in
Attaching the cable to jar posts
in this chapter.
4. Repeat the steps in
Attaching the cable to jar posts
and
Attaching the cable to a strap
in this
chapter until you are
fi
nished testing the string.
5. Refer to
Chapter 7: Test results
to view test results or
Retesting jar posts or straps
below to
retest the set of jar posts or straps.
Chapter 6: Testing
Celltron ULTRA
