Panel Functions 91
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual logiJET TM4
Edition 1.2p
8.3.4. Adjusting the Zero Position of the Material Transport (Sync.Sens.Offset)
Using this function an
offset
from the detected paper feed zero-
position can be set. (See figure next page) By this the position of
printout and tear off/cut
is adjusted
relatively to the
material
. (TOF, offset from the printer-detected punch position, that
means relatively to the gap/perforation and start of the label. The
setting range for the offset is approximately
± 20
mm.
Note: You should execute this offset adjusting after having adjusted the Sync
sensors successfully (see previous sections).
Panel display
Notes
[Online ]
Turn the printer OFF LINE with this key.
[Menu Level 1 ]
. . .
Press the
or
key until
[Engine
] is displayed.
[Engine ]
Press this key. This selects the Engine
menu.
[Printspeed ]
. . .
Press the
or
key until
[Sync.Menu
] is displayed.
[Sync.Menu ]
Press this key. This selects the Sync menu.
[Sync.Sens.Type ]
. . .
Press the
or
key until
[Sync.Sens.Offset] is displayed.
[Sync.Sens.Offset]
[Offset: +0.0 mm ]
The currently set offset value is displayed.
. . .
Press the
or
key until the
desired offset is displayed.
