Microcom 334M, Operator'S Manual

Page: 31 / 237

Getting Started Chapter 3
3-13 334M Operator’s Manual - 880060-0110
Sending a ^A1^D108 would set the printer to the 2 Port Autoselect between the USB or the
XPORT Ethernet port.
Sending a ^A5^D108 or ^A6^D108 command would set the printer to either use the
Microcom Ethernet Option board or to the 3 Port Auto Select (Serial, USB, or Microcom
Ethernet).
3.4 Qualsoft Windows Driver
3.4.1 Installing the Windows Driver
This section explains the driver installation process. The Qualsoft Windows print driver may
be used with Windows 7, 8.1, and 10 operating systems. If the printer is intended to be
used on a USB connection, the appropriate USB driver must be installed before the printer
is able to be used with the driver. The X38 based products use an FTDI based driver while
the X85 based products use a Microcom Corporation based driver.
The driver requires that the User has ADMIN privileges in order to install the driver. The
installation process sample shows the Windows 7 installation.
1. Right click on the installer, and select “Run as administrator”.