Microcom 334M, Operator'S Manual

Page: 87 / 237

Printer Commands Chapter 5
5-5 334M Operator’s Manual - 880060-0110
Text Mode Response
Byte Mode
Response
Definition
>RESTARTED< 1A Printer has been reset
>READY< 06 Normal condition
>CUTTER ERROR< 07 Cutter cannot rotate
>TAKE LABEL< 16 Printer is waiting for label to be taken
>LOW STOCK< 19 Media supply is low or out
>INPUT 1< 0E Input sensor #1 active
>INPUT 2< 21 Input sensor #2 active
>TRAY FULL< 09 Printed label tray is full
>PRINTER PAUSED< 10 Printer is paused
>TOF ERROR< 1F Top of Form is not sensed properly
>OVER VDD< 1E VDD voltage is out of operational range
>UNDER VDD< 1C VDD voltage is out of operational range
>OVER TEMP< 1D Print Head is too hot
>DATA ERROR< 15 Communication error
>STOCK NOT LOADED< 22 Printer power on without media installed.
>BUTTON PRESSED< C0
Print button configured to report message
when pressed.
>LPD STOCK JAM< 11
Reports when jams are detected. Switch 8
position 8 enables this feature
>BROWNOUT RECOVERY<
Printer entered and recovered from a
brownout power condition
>FAIL TIMEOUT<
Timeout failure occurred using the D149
Image Print Mode
>FAIL SIZE<
Incorrect size of the image was received
using the D149 Image Print Mode
>NO FLASH DATA FOUND<
The printer was unable to locate a valid
configuration and is forcing the default
configuration or “birth” pattern.
>CHECKSUM
VERIFICATION FAILED<
Configuration checksum does not match
printer will attempt to restore configuration.
>FLASH READBACK
FAILED<
The printer failed to read and verify the
configuration parameters are present.
>ERASE FAILED FOR
SECTOR n<
The flash was unable to erase at the
memory sector noted by the “n”
Table 5-1 Enquiry Responses