Microcom 334M, Operator'S Manual

Page: 130 / 237

Chapter 5 Printer Commands
334M Operator’s Manual - 880060-0110 5-48
Bit Position
(12345678)
Definition Operation
1 Reserved NA
2 Reserved NA
3 PSO (Pre Stock Out)
1 = Stock Detected
0 = No Stock Detected
4 Input 2 See Sw3-4 (D23)
5 Input 1 See SW3-2 (D23)
6 LTS / TOF
1 = Stock Detected
0 = No Stock Detected
7
Transmissive
Registration Sensor
1 = No Stock Detected
0 = Stock Detected
8
Reflective
Registration Sensor
1 = No Stock Detected
0 = Stock Detected
Table 5-5 Sensor Status Byte Definitions
^A ^D COMMAND
X 178 Pre-takeup Delay: This command is used in conjunction with the Takeup
feature of the printer and requires that takeup code is installed in the PIC and
is also enabled by the ^D26 command. The command delays the start of the
takeup motor by the X value in steps after the main motor starts. The valid
range is 0 to 65535 steps. Please note that if a value is selected that exceeds
to format LSY, the takeup would not turn on.