Microcom 334M, Operator'S Manual

Page: 30 / 237

Chapter 3 Getting Started
334M Operator’s Manual - 880060-0110 3-12
3.3.2.4 LDS1 Commands – Microcom Ethernet Option
The LDS1 commands may also be sent to the printer to configure the Microcom Ethernet
Option. The ^D177 command is used to configure the Ethernet option. A basic summary is
included below; for more detailed information, please refer to the ^D177 command in
Chapter 5.
1. LDS1 Description
2. ^A0^D177 Compare and save parameters
3. ^A1^D177 Change IP address
4. ^A2^D177 Change TCP port
5. ^A3^D177 Change DHCP enablement
6. ^A4^D177 Change NetBIOSName
7. ^A5^D177 Change Gateway
8. ^A6^D177 Change Subnet Mask
9. ^A7^D177 Change MAC address
10. ^A8^D177 Display printers current Ethernet parameters
11. ^A9^D177 Save current parameters
3.3.3 Configuring the printer to use Ethernet
Before the printer uses the Ethernet port, the printer must also be configured to use the
ethernet port by using the ^D108 command. See the ^D108 command under Chapter 5 for
additional information.
Modes 1 (^A1^D108) sets the XPORT/USB Autodetect while modes 5 (Microcom Ethernet
Option) and 6 (3 Port Auto Select) may be used to configure the printer for Ethernet usage.
Turn the printer ON with the print button pressed and held in. Release the button after the
printer status light turns a solid Green. This is the diagnostics mode that may be used to
connect to the printer to set the appropriate ^D108 command setting.
Using a Terminal Program, like MCT connect to the active printer port (typically Serial or
USB) and send the appropriate ^D108 command to the printer.
The MCT screen capture below shows a printer connected to the USB port with the ^D29
being issued. The Port is set to Auto select so this would auto select between the Serial
and the USB port.
LDS1 Description
^A0^D108 Auto select
^A1^D108 2 Port Auto Select
^A2^D108 Onboard USB
^A3^D108 Onboard RS-232
^A4^D108 Onboard USB
^A5^D108 Ethernet Option Board
^A6^D108 3 Port Auto Select