MICRO-EPSILON optoNCDT ILR 1183, Operating Instructions Manual

Page: 34 / 48

Page 34
Profibus Interface
optoNCDT ILR 1183
18 ... 19 0 bool E15 – reflex signal to weak, use target board
1 bool E16 – reflex signal too strong, use target board
2 bool E17 – steady light (that means insolation)
3 bool
E18 – only in DX-mode (50 Hz): variance between measured and
precalculated value too great
4 bool E23 – temperature below – 10 °C (+ 14 °F)
5 bool E24 – temperature above + 60 °C (+ 140 °F)
6 bool E31 – wrong EEPROM checksum, hardware error
7 bool
E51 – failure to set avalanche voltage of laser diode; cause: stray
light or hardware error
8 bool E52 – laser current too strong / defective laser
9 bool
E53 – failure to set one or more parameters in EEPROM (conse-
quence: division by 0)
10 bool E54 – hardware error (PLL)
11 bool E55 – hardware error
12 bool E61 – selected parameter is illegal; invalid command was triggered
13 bool
E62 – 1. hardware error 2. false value for interface communications
(SIO parity error)
14 bool E63 – SIO overflow
15 bool E64 – SIO framing error
20 ... 21 word warnings – unused (=0)
22 ... 23 word warnings – unused (=0)
24 ... 25 word profile version (for example 1.1 = 0110 hex)
26 ... 27 word software version (for example 1.11 = 0111 hex)
28 ... 31 unsigned 32 operating time (of laser), in units of 0.1 hour
32 ... 35 signed 32 offset value (see Chap. 7.6)
36 ... 39 signed 32 manufacture offset – unused (=0)
40 ... 43 unsigned 32 unsigned 32 measuring units per revolution – unused (=0)
44 ... 47 unsigned 32 unsigned 32 measuring range – unused (=0)
48 ... 57 10 byte 10 byte serial number