Rev. 112206.1
Page 7
Packing Materials
Please retain the original box and packaging in the event that the unit
requires future servicing. This will help to reduce the possibility of damage
occurring in transit. In the event that the system is shipped back to MF
DIGITAL without the original box and packaging, customers will be
charged for new box and packaging.
The Best Place To Put The ScribePC
The best operating location for the ScribePC duplication system is in a
climate controlled area, free of dirt, dust, humidity, excessive heat, and
electronic or electromagnetic interference. Room temperature should be
between 65 and 75 degrees Fahrenheit, or between 18 and 23 degrees
Celsius. Place the ScribePC on a solid, steady work surface and allow
sufficient room for all incidental work materials. Provide at least six inches
of clearance on all sides of the unit for ventilation.
Like all automated copiers, the Scribe uses photo sensors that can be
adversely affected by direct light sources. Avoid placing the system in
direct sunlight, under halogen or mercury vapor lights, or other close and
very bright light sources. If your Scribe is behaving erratically, and it is in
close proximity to bright light, or focused lighting such as spot lights, try
moving it to an area with more subdued lighting. If the unit operates
normally, then you may need to remove or adjust the light source, or
relocate the Scribe to a different spot.
Safety Precautions
The system is shipped with a three-prong power connector and must be
used with a properly grounded AC receptacle.
DO NOT
try to defeat the
third “ground” prong. All computer peripherals must be properly grounded
and the ScribePC is no exception. The use of a power conditioner such as
an Uninterruptible Power Supply (UPS), or a surge protector is highly
recommended. The minimum required size is 400VA.
Repairs or alterations should only be attempted by authorized factory
trained technicians. MF DIGITAL reserves the right to void the warranty if
unauthorized service is performed.
