A 1632
eMobility Analyser
Analyser operation
13
4.2.1 How to select or change the operating mode
Setup procedure
Switch OFF the eMobility Analyser.
Press and hold U
INPUT
key for at least 5 s while switching ON the adapter (ON/OFF
key). (Alternatively apply Mains supply while pressing and holding U
INPUT
key for at
least 5 s.)
When releasing the U
INPUT
key, beep sound indicates the newly set mode:
Single beep
Mode 1 selected
3 - beeps
Mode 2 selected
eMobility Analyser is now ready to operate in new operating mode.
Note:
Repeat upper procedure to toggle between operating modes.
4.3 Operation in autonomous mode
In this operation mode there is no need for data connection with master instruments. The
Remote LED is switched OFF. The eMobility Analyser test condition can be set with the switches
and keys on the
analyser’s front panel.
4.4 Remote operation
For remote setting of test condition, the eMobility Analyser must be connected via Bluetooth with
the Metrel safety tester first. See
Supported Instruments Selection Table
and instrument
’s
Instruction manual, chapter
Settings
for more information. The Analyser Remote LED is lit ON
and indicates that it is controlled by the Instrument. While in remote mode the a
nalyser’s keys
are not operating (except the On/Off key) and the state of rotary switches is irrelevant. The test
parameters are set by the instrument that controls the analyser.
Analyser Remote LED is lit ON only when associated Diagnostic test (EVSE) is selected on the
Instrument. When other Instrument safety test is selected, Analyser cannot be remote controlled
and Remote LED is lit OFF.
