MI 3394 CE MultiTesterXA
Maintenance
38
5 Maintenance
5.1 Fuses
There are four fuses on the front panel:
F1, F2: F 5 A / 250 V / (20
5) mm / 1500 A: intended for instrument protection.
For position of fuses refer to chapter
2.1 Front panel
.
F3, F4: T 16 A / 250 V / (32
6,3) mm / 1500 A: protection against over-currents through mains
test socket.
For position of fuses refer to chapter
2.1 Front panel
.
Warnings!
Switch off the instrument and disconnect all test accessories and mains cord before
replacing the fuses or opening the instrument.
Replace blown fuses only with the same types defined in this document.
5.2 Warranty & Repairs
Any potentially defective items should be returned to Metrel accompanied by information
regarding the faults that was incurred. It is recommended that any defective equipment is sent
back to Metrel via the Partner Distributor from which the product was purchased.
All defective products will be replaced or repaired within policy period. For these
items, a full refund will only be issued if a sufficient replacement is not available. Any shipping /
return-shipping costs are not refundable.
Metrel shall not be held liable for any loss or damage resulting from the use or
performance of the products. In no event shall Metrel be liable to the customer
or its customers for any special, indirect, incidental, exemplary or punitive damages
resulting from loss of use, interruption of business or loss of profits, even if Metrel has been
advised of the possibility of such damages.
If the customer’s unit is out of warranty but needs repairs, a quote for repair will be
provided via the Partner Distributor through which the instrument was sent in.
Notes
Any unauthorized repair or calibration of the instrument will infringe the product’s warranty.
All sales are subject to Metrel Standard Terms and Conditions. Metrel reserves the right to
change the conditions at any time. Any typographical, clerical or other error or omission in
any sales literature, quotation, price list, acceptance of offer, invoice or other
documentation or information issued by Metrel shall be subject to correction without any
liability on the part of the customer.
Specifications and designs of goods are subject to change by Metrel at any time without
notice to the customer. Metrel reserves the right to make any changes in the specification
of goods which are required to conform with any applicable statutory or EC requirements
or, where goods are to be supplied to Metrel specification, which do not materially affect
their quality or performance.
If a condition was found to be invalid or void it would not affect the overall validity of the
remainder of the conditions;
Metrel are excluded from liability for any delays or failure to comply, where the reason is
beyond Metrel control;
