Preparing the LATCH Assembly for Installation
1. Lay the front of the
restraint on a secure
surface (Figure A).
2. The restraint is shipped
with the LATCH
assembly stored through
the short belt path
(Figure A).
3. Since the LATCH must
be used through the
long belt path, it is
necessary to reroute
the assembly prior to
installing the restraint
with LATCH.
4. Loosen the LATCH
webbing by pressing the
release button on the
adjuster on the left and
pulling the webbing
through the adjuster
(Figure B).
Page 38
C
A
D
E
B
5. Unhook the end of the LATCH assembly that was
loosened in Step 4 (Figure C).
6. Route the end of the assembly up through the tilt bar
and insert it through the nearest seat belt slot (Figure
D) to the front of the restraint.
7. Place the end of the LATCH assembly over one side of
the restraint (Figure E).