Lap-Shoulder Belt Installation—Long Route, Contin-
ued
11. Remove slack from the
shoulder belt portion of the
lap-shoulder belt by pulling
up on the upper end of the
shoulder portion (Figure N)
and feeding the excess into
the retractor (Figure O).
12. Verify that there is no slack
in the seat belt. If there is
any slack, remove it as
described in Steps 10 and 11.
13. Review pages 24-29 to
determine the appropriate
method for locking your
vehicle seat belt and proceed
to lock it now.
14. Check the stability of the
restraint according to the
guidelines at the bottom of
page 29.
15.
Use of the tether(s) is
recommended, but not
required for this installation.
See Pages 42 & 43 for the
tether installation
procedure.
Note: To remove the
restraint, perform Steps 2-9
in reverse.
Page 33
N
O
