Page 35
Lap-Shoulder Belt Installation—Short Route—
Tether Required, Continued
5. Attach the seat belt to the buckle
(Figure E).
6. Remove as much slack from the
system as possible; first from the
lap belt portion by pulling up on
the lower end of the shoulder belt
portion (Figure F), then from the
shoulder belt portion by pulling up
on the upper end of the shoulder
belt (Figure G).
7. “Feed” all of the slack into the
shoulder belt retractor (Figure H).
8. Verify that there is no slack in the
seat belt. If there is any slack, re-
move it as described in Steps 6 and
7.
9. Review pages 24-29 to determine
the appropriate method for locking
your vehicle seat belt and proceed
to lock it now.
10.
Check the stability of the re-
straint according to the guidelines
at the bottom of page 29.
11. Use of the tether(s) is required.
See Pages 42 and 43 for the tether
installation procedure.
Note: To remove the restraint,
perform Steps 2-5 in reverse.
H
F
E
G