Mercedes-Benz R 350, Operator'S Manual

Page: 326 / 561

325
Controls in detail
Useful features
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
왘
Switch on the ignition (
컄
page 38).
왘
Press and hold the desired signal
transmitter button (
2
,
3
or
4
).
Do not release the button.
왘
The indicator lamp
1
will begin to
flash after 20 seconds. Without releas-
ing the signal transmitter button, pro-
ceed with programming starting with
step 3.
Operation of integrated remote control
왘
Switch on the ignition (
컄
page 38).
왘
Select and press the appropriate inte-
grated signal transmitter button (
2
,
3
or
4
) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
왘
Switch on the ignition (
컄
page 38).
왘
Simultaneously press and hold down
the outer signal transmitter buttons
2
and
4
, for approximately 20 seconds,
until the indicator lamp
1
flashes rap-
idly. Do not hold for longer than
30 seconds.
The codes of all three channels are
erased.
i
If you sell your vehicle, erase the codes
of all three channels.