mensor CPC3050, Operating Instructions Manual

Page: 73 / 128

Operating Instructions - CPC3050 73
High-Speed Pressure Controller
CPC3050
Srqmask? <sp>{string}<cr><lf> Returns “stable”, ”error” or “error,
stable” depending on the SRQ.
Sstop 1 or 2 Sets the serial and USB stop bits
Sstop? <sp>X<cr><lf> Returns the serial and USB stop bits
Stable? <sp>(Yes or No)<cr><lf> Returns YES if instrument is stable or
No
Stabledelay 0 to 3600 Sets the stable time to the number of
seconds specified
Stabledelay? <sp>XXXXXXX<cr><lf> Returns the stable time.
Stabletime 0 to 3600 Sets the stable time to the number of
seconds specified
Stabletime? <sp>XXXXXXX<cr><lf> Returns the stable time.
StableWin %FS value Sets the stable window as a %FS
StableWin? <sp>n.nn<cr>
<lf>
Returns the stable window.
Step Value inside upper and lower limits
and inside the range of the active
transducer.
Sets the control step size for the
instrument
Step- Jogs the setpoint down one step
Step+ Jogs the setpoint up one step
Step? <sp>+n.nn<cr>
<lf>
Returns the control step for the instru-
ment
Steppct Value in % of current range Sets the control step in % of current
range
Steppct? <sp>n.nn<cr>
<lf>
Returns the current step in % of cur-
rent range
Supply_Detect YES or NO Detects whether enough supply
pressure is connected, see Section
6.4.3.8 Detection Flags
Supply_Detect? <sp>(YES or NO)<cr><lf> Returns whether detection is enabled
Tare ON / OFF Tares the reading to zero
Tare? <sp> n.nn <cr><lf> Returns value of Tare
Temp? Read temperature
TEMPUNITS? Read temperature units (C, F, or K)
TEMPUNITS <sp>(C, F, or K)<cr><lf> Sets the temperature units to Celsius,
Fahrenheit, or Kelvin.
Termchar CCCC Set the output termination
character(s). CR, LF, CRLF, DEFAULT,
EOI, NONE
Termchar? Returns the termination character
setting
Touchcal Initiates a touchscreen calibration.
Transfer_factory_to_
linearity
Copy factory linearity coefficients to
customer
Units units code or text in table below Sets the instrument engineering units