Chapter 3
– Initial start-up
16
Electrical connection
Provide the following electrical connections for the steam
sterilizer:
Electric circuit with 100 V and 50/60 Hz
Connected load 1400 W
16 A separate fuse protection
– at least Automat Type B
Protection from leakage current 30 mA
NOTICE
In order to prevent water damage, MELAG recommends the
use of a leak monitor.
Waste-water drain
The steam sterilizer can be connected to the drain via the one-
way drain
(see page 10,
Fig. 1/ (14)
).
The connection must be located below the steam sterilizer.
The one-way drain hose can be connected as follows:
To an existing sink drain
To a separate drain pipe when using the surface-mounted
siphon from MELAG ( not in the standard scope of
delivery)
You can reorder a 2-m long hose.
NOTICE
The waste-water hose must be laid dip-free with continuous
descent.
For waste-water paths which are longer than two metres we
recommend a fixed laying of HT (high temperature) piping by a
specialised installation firm.
Observe the following precautionary measures when
handling the mains cable and power plug:
Danger of injury!
■
Never splice or modify the mains cable.
■
Never bend or twist the mains cable.
■
Never pull on the mains cable to take it out of the socket.
Always take hold of the power plug itself.
■
Never place any heavy objects on the mains cable.
■
Never run the mains cable over places where it could be
squeezed (e.g. doors or windows).
■
Do not run the mains cable along a heat source.
■
Do not use any nails, staples or similar objects to fixate a
cable.
If the mains cable or the power plug is damaged, turn off the
steam sterilizer. Mains cables or power plugs may only be
replaced by →authorised persons.
If these points are not observed, the cable or plug can be
damaged and/or a fire or electrical shock might occur.
Serious injuries could be the consequence.
Insert power plug into the socket
Plug the power plug into the socket.
