Meinberg LANTIME, Operating Instructions Manual

Page: 31 / 153

Menu SHS State
The SHS state is displayed automatically whenever a time limit error occurs, i.e.
the deviation between GPS time and PZF time is larger than the configured limit.
After powering-up the LANTIME this menu is displayed as long as the time deviation
is larger than the time limit. After the deviation becomes smaller than the time limit,
the main menu is displayed automatically. However, if a time limit error occurs
during the normal operation (not after powering-up) the error must be acknowledged
to change back to the normal operation by pressing the CLR/ACK key in the SHS
state menu. It is also possible to acknowledge the error by a modification via the
HTTP interface. An acknowledgement is essential even if the time limit error has
settled itself! Generating time strings again starts not before the acknowledgement
took place.
SHS STATE
DIFF: <1ms
GPS: sync
PZF: sync
Note: As long as both of the two LEDs FAIL and LOCK blink simultaneously, a
time limit error took place and no time string is sent to the NTP.
Menu RECEIVER POS.
This menu shows the current receiver position. The NEXT key lets the user select
one of three formats. The default format is geographic latitude, longitude and altitude
with latitude and longitude displayed in degrees, minutes and seconds. The next
format is geographic too, with latitude and longitude displayed in degrees with
fractions of degrees. The third format displays the receiver position in earth centred,
earth fixed coordinates (ECEF coordinates). The three formats are shown below:
RECEIVER POS.
Lat: 51°59’00”N
Lon: 9°13’35”E
ALT: 187 m
RECEIVER POS.
Lat: 51.9835°
Lon: 9.2236°
ALT: 187 m
RECEIVER POS.
x: 3885597m
y: 631166m
z: 5001820m
31