Megger TDS40, Operating Manual, Page: 53 / 71

6-53
6.6 Re-Setting the System Settings / Deleting the Print Templates
The user interface of the test and diagnosis system allows you to reset the non-volatile
system settings back to the default factory settings and to delete permanently stored print
templates.
After administrator rights have been gained as described in section 5.4, the “Memory”
menu can be accessed via the “Setup” menu. The functions of this menu can be activated
by pressing the F1 key or F2 key respectively. By pressing the knob / push-button the
menu can be left without triggering a function.
Fig. 37: Setup: Memory
„F1: Reload setup” resets all parameters and system settings to the default factory
settings. The administrator password is not affected (see section 5.4).
“F2: Delete Texts” resets all print templates (individual header lines and footer lines)
stored on the system (see section 6.3).
Hint:
These functions are not accessible, if a System Card inserted.
Memory <A>
F1: Reload setup
F2: Delete texts
F1/F2? else OK