Megger TDS40, Operating Manual, Page: 44 / 71

6-44
6.3 Internal Protocol Printout
Systems, that are equipped with a protocol printer (Fig. 3, item 8), offer the opportunity to
print those data that have been logged during the cable test.
By pressing the F2 key (Fig. 3, item 5) and turning the knob / push-button (Fig. 3, item 6)
the "Protocol" menu can be accessed. Here you can change the settings of the printer by
adjusting the “Print” parameter. The value of the parameter can be changed by rotating the
knob / push-button (Fig. 3, item 6) and can be accepted / saved by pressing it.
Fig. 30: Setup: Protocol printout off
Fig. 31: Setup: Protocol Printout Standard
After a cable test has been finished, the protocol printout can be triggered from the start
menu (Fig. 9) by pressing the F1 key once or repeatedly.
Depending on the print settings (see above), the following information are included in the
printout:
• Printout "Standard":
- Header (extended by the header from the SystemCard (if specified))
- System type and version
- Mode of operation, test voltage, test time
- Date / Time of test start
- Result of the test
- Measured data (time, test voltage in kV, leakage current in mA) of the test
(affected by the “print time points” set on the SystemCard (if specified))
- Footer (extended by the footer from the SystemCard (if specified))
- Date / Time of the printout
Protocol
Prot.: Extended
*Print: Standard
Set print mode ?
Protocol
Prot.: Extended
*Print: Off
Set print mode ?