MD 81777
EN-37
EN
If the device does not respond as expected, repeat the programming, or
try a different manufacturers code. Select the code to which most of the
remote control commands react correctly.
If this is also unsuccessful, the try one of the search methods described in
the following sections.
Manual code search
Carry out a manual search as follows:
1. Switch the relevant device on manually.
2. Keep the
CODE
key pressed for approx. 3 seconds until the red LED
remains solid.
3. Briefly press the required souce key (
TV
,
SAT
,
AUX
).
4. Keep pressing the (up to 350 times)
POWER
,
P+
or
P–
or (VCR only)
until the device that is to be controlled switches off, changes
channels, or responds accordingly.
5. The code search begins at the currently stored number.
6. Briefly press
ENTER
to save the code.
Due to the considerable quantity of different code numbers, up to 350
different codes are pre-programmed per device type. In individual cases it
may be possible that only the most common main functions are available.
The process described here may not work for some special models.
Automatic search
If your device does not respond to the remote control, even though you
have tried all of the codes listed for your device type and the relevant
brand, then try using the automatic search. This will enable you to find
codes for brands that were not listed in the device Code List.
1. Switch the relevant device on manually.
2. Keep the
CODE
key pressed for approx. 3 seconds until the red LED
remains solid.
3. Briefly press the required souce key(
TV
,
SAT
,
AUX
).
4. Point the remote control at the device and briefly press the button
P+
once.
5. If the device has no program function, press
P+
or
POWER
instead.
6. The remote control starts the code search after 6 seconds and
transmits all codes consecutively at 1-second intervals (see also next
section). The source key will light up for each transmission.
7. As soon as the device responds to the remote control, press
ENTER
.
– If you did not press
ENTER
at the right time, you can return to the
code to which the device responded step by step by pressing
P–
key.
To cancel the search, press
EXIT
.
1 second or 3 second intervals
If you want the remote control to transmit a new code every 3 seconds
instead of every second, proceed as follows:
Within 6 seconds of pressing the
P+
(or
POWER
) key as described in Point
4 press the
P+
or
P–
key again. The remote control will now only transmit
a new code every 3 seconds. This gives you more time, but the procedure
will also take longer.
