MD 81777
EN-33
EN
Channel delay
If you connect separate loudspeakers they should ideally be set up in a
circle (refer to left side of the diagram). If this is not possible you can
compensate for differences in the circle shape here.
In the example below (see the right side of the illustration) the left and rear
left loudspeakers are moved by 50 cm and by 40 cm for the rear right
loudspeakers.
`
Use the navigation button to enter the graphical fields next to the
Channel Delay
entry. Select one of the loudspeakers by pressing
or . Using the or buttons to increase or reduce the value in units
of 10 cm. The maximum distance that can be set between speakers is
600 cm. Confirm with
ENTER
and exit the menu with .
The circle is defined by the front loudspeakers. That is why you cannot
select the front loudspeakers.
DOLBY DIGITAL menu
Dynamics
The Dolby Digital sound format supports a dynamic setting, which you
can use to set the volume difference between quiet and loud passages
with a scale of
OFF
to
FULL
in nine steps.
Off
:
The sound is reproduced without changes, i. e. loud
passages and bass sounds are loud and quiet passages are
quiet (cinema sound). This setting is only appropriate if
nobody will be disturbed.
FULL
:
The volume difference is minimised, i. e. loud passages are
quieter and quiet passages are louder. This setting is
appropriate, for example, at night.
`
To change the setting use to access the scale on the right hand side
and then use or to selected the desired value. Confirm with
ENTER
.
