MCZ Vivo 85 Hydro, Installation Manual

Page: 63 / 76

61
10-CLEANING AND MAINTENANCE
Technical Dept. - All rights reserved - Reproduction is prohibited
Ash pan cleaning
Remove and empty ash pan “D”. Wipe away any residual ash before reinserting the pan. Your experience and the quality of the pellets will
determine the ash pan cleaning frequency. However, it is recommended not to exceed 2 or 3 days.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specific detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass cleaning product on the painted parts and on the door
gaskets (ceramic fibre cord).
CLEANING THE HEAT EXCHANGER
The compartment through which the exhaust smoke passes must be cleaned at the end of the winter season.
This cleaning process is mandatory in order to facilitate the general removal of all combustion residue, before it becomes very difficult to
remove it due to the humidity compacting it over time.
If necessary, clean it more often.
It is good practice to guarantee effective ventilation in the room while cleaning the product.
When the appliance is cold, clean the steel walls of the firebox, especially the back of it, with a scraper/pallet (included), to
remove any build-up caused by soot. Build-up acts as insulation, and the thicker it is, the less heat is transferred to the water
and to the structure in general.
When cleaning is finished, re-assemble everything by following the instructions in reverse order.
CLEANING THE UPPER EXCHANGER
Open aesthetic door “A” and clean the turbulators. Lower and raise the two levers located inside aesthetic door “A” several times.
Doing so will remove any soot that has deposited in the exchanger’s smoke ducts during normal boiler operation.