MCZ Vivo 85 Hydro, Installation Manual

Page: 33 / 76

31
5-PRECAUTIONS BEFORE START-UP
Technical Dept. - All rights reserved - Reproduction is prohibited
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!! THE PRODUCT NEEDS SOME RUNNING-IN TIME.
It is extremely important to make sure the product does not reach high temperatures straight away, but to increase the
temperature gradually using low power at first.
This will prevent damage to the welds and the steel structure.
Do not touch the product during the first lighting, as it is during this phase that the paint sets. If you touch the paint,
you may expose the steel surface.
If necessary, touch up the paint with the spray can of the specific colour.
ELECTRICAL CONNECTION
First connect the power cable to the rear of the product and then to a wall socket, which must always remain accessible.
Should this not be possible, during installation insert suitable devices for disconnection from the power mains, in compliance with
national electrical installation standards.
It is recommended to disconnect the power cable when the product is not in use.
The product is turned on from the ON/OFF switch on the pellet loading hatch.
Before doing anything to the product, it is necessary to disconnect it from the 230 V power supply.
If during operation or initial ignition you encounter combustion smoke spillage in to the room from the
appliance or the flue then please switch off the appliance, ventilate the room and contact the installation
/ service technician immediately.