MCZ Vivo 85 Hydro, Installation Manual

Page: 47 / 76

45
6-HYDRAULIC CONNECTION
Technical Dept. - All rights reserved - Reproduction is prohibited
RECIPE SELECTION PROCEDURE
On the control panel menu, the word “Ricetta (Recipe)” will appear under the settings menu. This function is designed to increase or
decrease hopper pellet loading, and is represented as follows:
• To increase it: +1 +2 +3 equal to 10-20-30% more than the standard factory setting recipe.
• To decrease it: -1 -2 -3 equal to 10-20-30% less than the standard factory setting recipe.
CHIMNEY SWEEP FUNCTION
CAUTION.
The “Spazzacamino (Chimney sweep)” function is a technical function provided for specialised technicians, for
product calibration (when required by law), which the User must never run.
To start the Chimney Sweep function you need to enter MENU-IMPOSTAZIONI (SETTINGS)-SPAZZACAMINO (CHIMNEY SWEEP) (after °C-°F).
When the function is running, the stove will operate at maximum power (loading, smoke ventilation, room ventilation) without taking
into consideration any change/off requests from the external (thermostat, eco-stop, modem, home automation control) and internal
probes. The only limit that needs to stay active is the 85°C safety threshold in the boiler, and the relative electronics will switch off if this
parameter is exceeded.
The test will work until the technician decides to disable the function by pressing esc of the on/off button.
REGULATING WATER TEMPERATURE IN BOILER
The stove is already set with a series of standard parameters which make correct operation possible (water temperature 65°C). The water
temperature will be displayed on the control panel screen.
If the user wishes to change the temperature parameters, he/she can do so as follows:
T H2O - Maximum temperature of water in boiler. Upon reaching this temperature, the stove will reduce its performance to prevent
overheating.
The default temperature is 65°C and it can not be set below 50°C or over 80°C.
To adjust it: press any key; press “menu”; use the scroll keys to view the “SET TEMP.H20” screen; press the “SET” key; set the required
temperature using the “<>” scroll keys; confirm the temperature with “OK”.