Chapter 2
INSTALLATION AND USE MANUAL
page
9
Theoretical notions for installation
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
MCZ strongly recommends using certified fuel in its
stoves.
The use of fuel of inferior quality or not conforming
to the specification given above compromises the
running of your stove and can therefore lead to the
termination of the guarantee and of the
manufacturer's responsibility for the product.
MCZ pellet stoves run exclusively on pellets with a
diameter of 6 mm (only for Italy) and 6-8 mm
(European countries) with lengths that go from 5
mm to 30 mm.
2.2.
PRECAUTIONS FOR INSTALLATION
IMPORTANTE!
THE INSTALLATION AND ASSEMBLY MUST BE
CARRIED OUT BY QUALIFIED PERSONNEL.
All local regulations, including those that refer to
national and European regulations, must be observed
at the time of installation of the unit
The stove must be installed in a suitable position to allow the normal
operations of opening and ordinary maintenance.
The site must be:
•
capable of providing the environmental conditions for operation
•
equipped with power supply 230V 50 Hz (EN73-23)
•
capable of taking an adequate system for smoke discharge
•
provided with external ventilation
•
provided with an earth connection complying with CEI 64-8
IMPORTANT!
•
THE PRODUCT MUST BE CONNECTED TO AN
INTERNAL OR EXTERNAL FLUE PIPE IN
COMPLIANCE WITH CURRENT STANDARDS.
•
The product must be connected to a flue pipe or
other vertical smoke stack that can discharge
smoke at the highest point of the house.
•
Smoke is generated from burning wood and,
therefore, may dirty adjacent or nearby walls.
Also take care because the fumes are very hot but
almost invisible, and can cause burns on contact
.
•
Before positioning the unit, a hole must be made
for the passage of the smoke pipe, and another
for the intake of air from outside.
•
The electrical plug must be positioned where it is
always accessible. Otherwise, during installation,
provide suitable devices for disconnection for the
power supply network in compliance with
standards on electrical systems
